AD 700 Desiccant Compressed Air Dryer One (1) Month Minimum Rental Period
The AD 700 is a skid mounted deliquescent air dryer with a drying capacity of approximately 700 CFM of air at 150 PSIG. This unit is ideal for drying air for abrasive blasting operations, accommodating 2-3 blasters, depending on nozzle size. The contractor may choose to use either the air powered turbo after cooler (air to air) heat exchanger or the water cooled (water to air) heat exchanger but only one heat exchanger can be used at a time. Desiccant tablets remove the moisture from the air.Mounted on a sturdy protective frame with fork lift tubes and certified lifting eyes, the air dryer can be moved into position with either a fork lift or overhead crane. The 3” piping system has a particulate filter to trap solid particles, is large enough to reduce pressure loss in the piping and also allows by-passing the drying system for service without interrupting air service to the equipment upstream. An air motor enables the system to operate totally without electrical power when using the manual moisture drain valve. If 120 Volt AC power is available, the automatic spit valve drain system can be used. Air Dryer Spare Parts
Specifications: Length 5’-6” Height 6’-5” Width 5’-5” Weight 3,600 lbs. (Full of desiccant) Voltage 120 VAC (not needed if manual drain is used) Features: Skid mounted. Structural steel frame protects equipment. Forklift pockets. Certified lifting eyes (4 each) for handling by overhead crane. AIR to AIR Heat Exchanger or Water to Air Heat Exchanger. (Unit can be used with either one of the heat exchangers above) Air powered fan motor for air to air heat exchanger. Desiccant tank is ASME rated @ 150 PSI. System is rated for 150 PSI @ 700 SCFM. 3” inlet and outlet air piping to reduce pressure drop through the system. Sight glass in desiccant tank for visual inspection of desiccant level. Manual or electric moisture drain on the desiccant tank. System is equipped with desiccant tank by-pass piping. Notes: 1. Not intended to be laid on its side. 2. Air (bull) hoses and fittings not provided for connection of equipment. 3. Additional charges may apply for desiccant used during the rental period. 4. Not intended to be used with air compressors with high levels of oil in the air discharge.