DC 4,000E, Portable Electric Dust Collector One (1) Month Minimum Rental Period
This 4000 CFM dust collector was designed by SAFE Systems to provide the contractor maximum flexibility and reliability. Skid mounted, with both fork lift pockets and certified crane lifting eyes, the compact unit can easily be positioned in an optimum location. The extendable legs raise the unit to accommodate a 55 gallon drum or other collection device under the dust hopper and then adjust to allow low profile shipping. A built-in platform under the hopper makes handling the drum quick and easy. One (1) 18” duct connection makes connecting vent hose quick. A large, container-style doormakes filter access easy. Airflow through the dust collector can be regulated with the inlet damper. Four (4) cartridge filters collect the dust particles and are cleaned by a reverse pulse jet of compressed air, one row of two (2) filters, at a time. The dust particles then fall into the hopper below that is equipped with a slide gate for quick dumping of the dust. Belts and drives are eliminated by the direct-drive 15 HP motor. The NEMA 4 control box is dust and water tight to protect the electrical controls from contaminants and moisture. The unit comes with 25’ of the properly sized SO cord to allow electrical connection at the job site. One large, easy to open/close “Container Style” door gives quick access to the filters and dust hopper. The latching, hinged duct cover means you no longer have to keep track of an unattached duct cover. Dust Collector Spare Parts
Specifications: Manufacturer: SAFE Systems, Inc. Length 7’-8” Width 8’-5” Height 1’-1” (Shipping position) Height 12’-6” (Working position) Weight 3,200 lbs. (completely empty of dust) Horsepower 15 Voltage 460 VAC, 3 phase Full load Amps 18 Features: Skid mounted. Extendable legs. Forklift pockets. Certified lifting eyes for handling by overhead crane. Fan and dust collector rated for 4,000 CFM @ 12” WC. One (1) dust inlet, 18” diameter with latching, hinged cover. Automatic reverse pulse cleaning system for filters. ¾” air piping for pulse cleaning system. Air requirements for pulse cleaning system, 20 CFM @ 90 to 100 PSIG. Fan is direct driven by a 15 HP, 480-volt, 3-phase electric motor. 480 volt AC , 3 phase controls in weather-tight control box. Four(4) cartridge filters, part # 1000 0450. Adjustable inlet damper on the fan for regulating the airflow. Slide Gate on the hopper dust discharge. Dust discharges onto standard 55 gallon drum (drum supplied by customer) Platform built-in for dust drum 25’ of properly sized SO cord for electrical hook-up. Notes: 1. Not intended to be shipped with any dust in collection hopper. 2. Recommend emptying dust every 2 to 4 hours depending on collection rate. 3. It is recommended that a qualified electrician connect this equipment to power and check for correct motor rotation. 4. It is recommended that all new filters be coated with precoat dust prior to putting into service. 5. If operating this equipment using a generator, check with the generator provider to ensure proper sizing. We recommend at least a 30 KW generator for this piece of equipment. 6. We recommend shipping this piece of equipment on an open flat bed truck or trailer. Shipping in an enclosed box van or trailer is not recommended.