DC 7,100E Portable Electric Dust Collector
​One (1) Month Minimum Rental Period

This compact, portable dust collector has extendable legs that raise the unit to accommodate a 55 gallon drum or other collection device under the dust hopper and then adjust to allow low profile shipping. A direct driven 25 HP motor powers the 7100cfm exhaust fan. Control of the airflow through the dust collector is managed by an inlet damper. A large, container-style door makes filter access easy.
Versatility is built into this SAFE Systems machine. With one (1) 18” duct inlet on each side of the machine, the contractor can work from either side of this skid-mounted unit. Fork lift pockets and certified crane lifting eyes allow the contractor to easily place it in the most advantageous location.
Nine (9) cartridge-type filters collect the dust particles. An electronically controlled, reverse pulse jet of compressed air systematically cleans the filters, one row of three (3) filters at a time, to dislodge the dust particles which then fall into the hopper below. The dust hopper is equipped with a slide gate for quick dumping of the dust.
A NEMA 4 dust and water tight control box, protects the electrical controls from contaminants and moisture. The unit comes with 25’ of the properly sized SO cord to assist in electrical connection at the job site. Access to the filters and dust hopper, when necessary, is through one large, easy to open and close “Container Style” door.
Dust Collector Spare Parts

Specifications:
Manufacturer:  SAFE Systems, Inc.
Length                          9’-8”
Width                            8’-0”
Height                           8’-10½” (Shipping position)
Height                           12’-3¼” (Working position)
Weight                          5,500 lbs. (completely empty of dust)
Horsepower                 25
Voltage                         460 VAC, 3 phase
Full load Amps            28.05
Features: 
           Skid mounted. 
           Extendable legs. 
           Forklift pockets. 
           Certified lifting eyes for handling by overhead crane. 
           Fan and dust collector rated for 7,100 CFM @ 15½” W.C. 
           Two (2) dust inlets, 18” diameter (only 1 to be used at a time). 
           Automatic reverse pulse cleaning system for filters. 
           ¾” air piping for pulse cleaning system. 
           Air requirements for pulse cleaning system, 30 CFM @ 90 to 100                      PSIG. 
           Fan is direct driven by a 25 HP, 460-volt, 3-phase electric motor. 
           460 volt AC control box. 
           Nine (9) cartridge filters, part # 1000 0300. 
           Adjustable inlet damper on the fan for regulating the airflow. 
           Slide Gate on the hopper dust discharge. 
           Dust discharges onto standard 55 gallon drum (drum supplied by                      customer) 
           25’ of properly sized SO cord for electrical hook-up.    
Notes: 
1.      Not intended to be shipped with any dust in collection hopper. 
2.      Recommend emptying dust every 2 to 4 hours depending on collection              rate. 
3.      It is recommended that a qualified electrician connect equipment to power          and check motor rotation. 
4.      It is recommended that all new filters be coated with precoat dust prior to          putting into service.
5.      If operating this equipment using a generator, check with the generator              provider to ensure proper sizing.We recommend at least a 56 KW                      generator for this piece of equipment.
6.      We recommend shipping this piece of equipment on an open flat bed                  truck or trailer.Shipping in an enclosed box van or trailer is not                          recommended.