DC 4,500E, Portable Electric Dust Collector
​One (1) Month Minimum Rental Period

This 4500cfm dust collector was designed by SAFE Systems to provide the contractor maximum flexibility and reliability.  Skid mounted, with both fork lift pockets and certified crane lifting eyes, the compact unit can easily be positioned in an optimum location.  The extendable legs raise the unit to accommodate a 55 gallon drum or other collection device under the dust hopper and then adjust to allow low profile shipping.  One (1) 18” duct connection makes connecting vent hose quick. A large, container-style door makes filter access easy.
Airflow through the dust collector can be regulated with the inlet damper.  Six (6) cartridge filters collect the dust particles and are cleaned by a reverse pulse jet of compressed air, one row of three (3) filters, at a time.  The dust particles then fall into the hopper below that is equipped with a slide gate for quick dumping of the dust.
Belts and drives are eliminated by the direct-drive 15 HP motor. The NEMA 4 control box is dust and water tight to protect the electrical controls from contaminants and moisture.  The unit comes with 25’ of the properly sized SO cord to allow electrical connection at the job site. One large, easy to open and close “Container Style” door gives quick access to the filters and dust hopper.
Dust Collector Spare Parts

Specifications:
Manufacturer:  SAFE Systems, Inc.
Length                             8’-6”
Width                               4’-10”
Height                             7’-11” (Shipping position)
Height                             11’-5” (Working position)
Weight                            2,500 lbs. (completely empty of dust)
Horsepower                     15
Voltage                            460 VAC, 3 phase
Full load Amps                 18
Features: 
            Skid mounted. 
            Extendable legs. 
            Forklift pockets. 
            Certified lifting eyes for handling by overhead crane. 
            Fan and dust collector rated for 4,500 CFM @ 12” WC. 
            One (1) dust inlets, 18” diameter. 
            Automatic reverse pulse cleaning system for filters. 
            ¾” air piping for pulse cleaning system. 
            Air requirements for pulse cleaning system, 30 CFM @ 90 to 100 PSIG. 
            Fan is direct driven by a 15 HP, 460-volt, 3-phase electric motor. 
            460 volt AC control box. 
            Six (6) cartridge filters, part # 1000 0300. 
            Adjustable inlet damper on the fan for regulating the airflow. 
            Slide Gate on the hopper dust discharge. 
            Dust discharges into standard 55 gallon drum (drum supplied by                       customer) 
            25’ of properly sized SO cord for electrical hook-up.
Notes: 
1.    Not intended to be shipped with any dust in collection hopper. 
2.    Recommend emptying dust every 2 to 4 hours depending on collection              rate. 
3.    It is recommended that a qualified electrician connect this equipment to            power and check for correct motor rotation. 
4.    It is recommended that all new filters be coated with precoat dust prior to          putting into service.
5.    If operating this equipment using a generator, check with the generator              provider to ensure proper sizing.We recommend at least a 30 KW generator        for this piece of equipment.
6.    We recommend shipping this piece of equipment on an open flat bed truck        or trailer. Shipping in an enclosed box van or trailer is not recommended.